CommPeak

To make calls via your PBX, you must register the necessary extension (device) in a softphone application or an IP phone. 

If the device is a fixed one, at this point, the agent is ready to make calls. For ad hoc devices, you should also be able to log the agent into the softphone/IP phone.

If you want more information about device types, please refer to the <a href="https://helpcenter.commpeak.com/en/articles/8079810">Devices</a> article.

To demonstrate the steps where a softphone application is required, we will use Zoiper, an application available for Windows, macOS, and Linux, as well as Android and iOS. This is third-party software used for illustration only. Instead, you can use <a href="https://helpcenter.commpeak.com/en/articles/8795543-configuring-a-device-and-logging-in-to-microsip-softphone">MicroSIP</a> or any other softphone available for download.

Below are the steps needed to start making calls for fixed and ad hoc devices. 

In PBX Stats, go to Configuration -&gt; Devices.

You can find the device you want to register in the softphone: you will need its credentials. To find out the password:

1. Click Reset Password in the Password column and proceed.

2. Copy the password in the following window.

Specify your device ID and password in the start window and click Login.

In the next window, enter your hostname (your PBX domain name followed by pbx.commpeak.com). 

Perform all the further steps needed to register the device. 

1. In PBX Stats, go to Configuration -&gt; Devices.
2. You can find the device you want to register in the softphone: you will need its credentials. To find out the password:
 1. Click Reset Password in the Password column and proceed.
 
 2. Copy the password in the following window.

3. Start your softphone application.
4. Specify your device ID and password in the start window and click Login. 
 2.png
5. In the next window, enter your hostname (your PBX domain name followed by pbx.commpeak.com). 
 3.png
6. Perform all the further steps needed to register the device. 
 4.png

Now your agent can <a href="https://helpcenter.commpeak.com/en/articles/8079844-agent-s-workspace-overview#h_48774bb484">log in to the agent workspace</a> and start making and receiving calls.

Configuring an Ad Hoc Device and Logging In an Agent

First, take the steps needed for a fixed device described in the previous section. 

In PBX Stats, go to Configuration -&gt; Agents.

Find the agent who will be using the previously registered device and take their login. 

In your softphone, dial *11 to start the agent log-in process. 

Then, using voice prompts, dial the agent's login and password, each followed with #. You will hear a voice message informing you that the agent is logged in.

Now the agent is ready to make and receive calls.

At the end of the shift, log out by dialing *12 on the keypad.

1. In PBX Stats, go to Configuration -&gt; Agents. 
2. Find the agent who will be using the previously registered device and take their login. 

3. To find out the password:
 1. Click Reset Password in the Password column and proceed.
 
 2. Copy the password in the following window.

4. In your softphone, dial *11 to start the agent log-in process. 
 7.png
5. Then, using voice prompts, dial the agent's login and password, each followed with #. You will hear a voice message informing you that the agent is logged in. 
 8.png
 Now the agent is ready to make and receive calls.
6. At the end of the shift, log out by dialing *12 on the keypad.

Configuring a Fixed Device

Configuring an Ad Hoc Device and Logging In an Agent